Near Railway Crossing, Jhotwara, Jaipur Raj., India
General Description of Bitumen Emulsion MS
Emulsion MS is used for plant or road mixes with coarse aggregates minimum 80 percent, all of which is retained on 2.36 mm. Our bitumen is processed using sophisticated technology and quality tested chemical compound in conformity with the predefined industry standards. This bitumen can be availed in various colors and can be customized as per information provided by our clients.
Premix Carpet: For economical and fast construction of wearing course, emulsion is used for Premix Carpet. Ministry of Road Transport & Highway (MORT&H) has also recommended use of emulsion for this application in their clause 506.2. A tack coat is applied on the cleaned surface. The cold mix is prepared as per the above method and spread over the existing surface followed by either liquid seal coat or a premix seal coat.
Maintenance Mix: This high quality material now makes it possible to fill pot holes or carry out patch repair with open graded cold premix made on-site. The methods typically used for the repair of pot holes using asphalt emulsions are throw-and-roll and full-depth removal and replacement. All of these methods involve placing cold mix in the pot hole with a shovel and compacting with a truck tire, vibratory plate compactor or steel wheeled roller.
|Residue on 600 micron
IS Sieve, percent by mass, Max
|Viscosity by saybolt furol viscometer, seconds
1) At 25℃
2) At 50℃
|Coagulation of emulsion at low temperature1)||Nil|
|Storage stability after 24 h, percent, Max||1|
|Coating ability and water resistance:
1) Coating, dry aggregate
2) Coating, after spraying
3) Coating, wet aggregate
4) Coating, after spraying
|Stability to mixing with cement (% coagulation), Max||–|
|Miscibility with water||No Coagulation|
|Tests on residue:
1) Residue by evaporation, percent, Min
2) Penetration 25℃/100g/5 sec
3) Ductility 27℃/cm, Min
4) Solubility I tricholoethylne, percent by
|Distillation in percent volume of distillate recovered at 360℃ at
5) Residue at 360℃, percent, Min
|Water content, percent by mass, Max||–|
1) This requirement shall be applicable only under situations where the ambient temperature is below 15℃.
2) The value of solubility is determined on distillation residue at 360℃