TODAY'S PRODUCT PRICES
INDUSTRIAL FUEL OIL (LITRE)LHSH- LOW SULPHER HEAVY STOCK (KGFURNCAE OIL (Kg)FOOD GRADE LDO (Litre)LDO-LIGHT DIESEL OIL (Litre)BITUMEN CRMB (BULK)BITUMEN VG-10 (BULK)BITUMEN VG-30 (BULK)BITUMEN VG-40 (BULK)BITUMEN EMULSION RS-1 (BULK)BITUMEN EMULSION SS-1 (BULK)BITUMEN EMULSION MS (BULK)
 

Bitumen Emulsion SS-1

General Description of Bitumen Emulsion SS-1

 

Emulsion SS1 is used for Prime Coat application and perform several important functions such as coating and bonding loose mineral particles on the surface of the base, hardening and toughening the surface of the base, waterproofing the surface of the base by plugging capillary or interconnected voids, and providing adhesion or bond between the base and the asphalt mixture. This grade of emulsion penetrate quite deep in WMM / WBM surface providing an effective Prime Coat.

Bitumen emulsion SS1 is slow-setting, anionic type and are further characterized by their ability to remain stable on storage although produced with equipment that generates a wide range of shearing forces. Such characteristics are imparted to the asphalt emulsions through the use of emulsion-conditioner compositions comprising a partially desulfonated lignosulfonate, preferably an anionic or nonionic emulsifying agent and, optionally, a thickene.

 

Specification:

Characteristics
Residue on 600 micron 0.05
IS Sieve, percent by mass, Max
Viscosity by saybolt furol viscometer, seconds
1) At 25℃ 20-100
2) At 50℃
Coagulation of emulsion at low temperature1) Nil
Storage stability after 24 h, percent, Max 2
Particle charge
Coating ability and water resistance:
1) Coating, dry aggregate
2) Coating, after spraying
3) Coating, wet aggregate
4) Coating, after spraying
Stability to mixing with cement (% coagulation), Max
Miscibility with water Immiscible
Tests on residue:
1) Residue by evaporation, percent, Min
2) Penetration 25℃/100g/5 sec
3) Ductility 27℃/cm, Min
4) Solubility I tricholoethylne, percent by 982)
mass, Min
Distillation in percent volume of distillate recovered at 360℃ at 20-55
1) 190℃ 30-75
2) 225℃ 40-90
3) 260℃ 60-100
4) 316℃ 50
5) Residue at 360℃, percent, Min
Water content, percent by mass, Max 20
  1. This requirement shall be applicable only under situations where the ambient temperature is below 15℃.
  2. The value of solubility is determined on distillation residue at 360℃